HENKEL HYSOL UNDERFILL UF3810 TDS&MSDS资料

汉高公司3月12日在官网发布了他们最新的底填胶水产品UF3810产品的相关新闻，官网TDS数据库里面也有对应的TDS资料。资料显示是2011年12月份发布的。摘录学习之：

PRODUCT DESCRIPTION

UF3810 provides the following product characteristics:

UF3810 reworkable epoxy underfill is designed for CSP and BGA applications. It cures quickly at moderate temperatures to minimize stress to other components. When cured, this material provides excellent mechanical properties to protect solder joints during thermal cycling.

TYPICAL PROPERTIES OF UNCURED MATERIAL
Viscosity, Cone & Plate,@ 25 °C , mPa∙s (cP):
@ 20 s-1 394
Specific Gravity, 1.13
Pot life @ 25 °C, 25% viscosity increase, days 3
Shelf Life @ -20°C (from date of manufacture), months 6
Flash Point – See MSDS

TYPICAL CURING PERFORMANCE
Cure Schedule    ≥8 minutes @ 130°C
The above cure profile is a guideline recommendation. Cure conditions (time and temperature) may vary based on customers’ experience and their application requirements, as well as customer curing equipment, oven loading and actual oven temperatures.

TYPICAL PROPERTIES OF CURED MATERIAL
Physical Properties:
Coefficient of Thermal Expansion , TMA, ppm/°C:
Below Tg 55
Above Tg 171
Glass Transition Temperature (Tg) by TMA, °C 102
Storage Modulus, DMA:
@ 25 °C N/mm² 2,990
(psi) (435,000)

Electrical Properties:
Dielectric Constant @ 23ºC :
@ 1GHz 3.44
@ 2GHz 2.87
Dissipation Factor @ 23ºC:
@ 1GHz 0.0071
@ 2GHz 0.0037
TYPICAL PERFORMANCE OF CURED MATERIAL
Lap Shear Strength , ISO 4587:  Glass Epoxy to Glass Epoxy N/mm² 9.7(psi) (1,400)

GENERAL INFORMATION
For safe handling information on this product, consult the Material Safety Data Sheet, (MSDS).
THAWING:
1. Thaw 30 cc syringes at least 1 hour at room temperature prior to use.
2. Allow container to reach room temperature before use.
3. After removing from the freezer, set the syringes to stand vertically while thawing.
4. DO NOT open the container before contents reach 25°C temperature. Any moisture that collects on the thawed container should be removed prior to opening the container.
5. DO NOT re-freeze. Once thawed to 25°C, the adhesive should not be re-frozen.
DIRECTIONS FOR USE
1. Thawed adhesive should immediately be placed on dispense equipment for use.
2. If the adhesive is transferred to a final dispensing reservoir, care must be exercised to avoid entrapment of contaminants and/or air into the adhesive.
3. Adhesive must be completely used within the product’s recommended work life.
Not for product specifications
The technical data contained herein are intended as reference only. Please contact your local quality department for assistance and recommendations on specifications for this product.
Storage
Store product in the unopened container in a dry location. Storage information may be indicated on the product container
labeling.

华为网盘下载：http://dl.dbank.com/c07tn5h5gj

注册本地下载：

  UF3810 TDS (63.4 KB, 15 次)
您没有权限下载此文件。

  UF3810 MSDS (44.5 KB, 10 次)
您没有权限下载此文件。